e.w.i.n.g.1 píše:
Takže mám nejdříve vylit starý olej.. nalit tam nový.. kolik mám najezdit km než to zase vypustím a naliju znovu olej? Jsem zvědavý, jestli vyteče celých 7 litrů....
Jak je to s naléváním toho oleje? To bude asi potřeba nějaký speciální trychtýř... pokud se to nalévá stejným místem, jak je měrka, tak tam je "parádní" přístup...
Caution! The oil may be very hot if the car has just been driven.
Remove plug and drain fluid from oil pan
Reinstall plug with new seal and tighten to 20 Nm.
Disconnect upper pipe from oil cooler
Always use wrench to counterhold oil cooler hexagonal-terminal when loosening or tightening union.
Install tool 999 5510
Place container under tube to collect fluid.
Apply parking brake and move gear selector lever to position P
Carry out the following:
Add approximately 2 liters of oil.
Start the engine and idle it.
Turn the engine off when air bubbles start to become visible in the hose.
Add another 2 litres (approximately) of fluid.
Start the engine again and idle it.
Turn the engine off when air bubbles start to become visible in the hose.
Remove tool 999 5510 and install the pipe on the oil cooler.
Add another 2 litres (approximately) of fluid.
Set parking brake.
Start engine and idle it, move the gear selector through all positions, stopping in each position for 4-5 seconds.
Move the gear selector to position P with the engine running.
Wait 2 minutes, then check oil level
Top up if necessary.
Shut off the engine.
Finishing
After repair check that no diagnostic trouble codes have been stored during the repair.