Jeden duvod jak jsem uz psal - on ten novej original ani moc pajet nejde (bosch co jsem kupoval par mesicu zpatky byl uplne bez sance, ale je mozny ze nejakej starsi origo kousek pajet pujde).standa píše:A proč by se to jako nemělo pájet???
Hlavni duvod (a taky duvod proc to vyrobce vyslovne zakazuje) viz zde.
"Older style oxygen sensors actually have a small hole in the body shell so air can enter the sensor, but newer style O2 sensors "breathe" through their wire connectors and have no vent hole. It's hard to believe, but the tiny amount of space between the insulation and wire provides enough room for air to seep into the sensor (for this reason, grease should never be used on O2 sensor connectors because it can block the flow of air). Venting the sensor through the wires rather than with a hole in the body reduces the risk of dirt or water contamination that could foul the sensor from the inside and cause it to fail. The difference in oxygen levels between the exhaust and outside air within the sensor causes voltage to flow through the ceramic bulb. The greater the difference, the higher the voltage reading."